TRAXXAS TRX4 Trail Crawler Aluminum Front/Rear Bumper D-rings by GPM TRX4002  [TRX4002]

Aluminum bumper D-rings for scale rigs

This GPM TRX4002 set provides four aluminum D-rings intended for scale trail crawler use on TRAXXAS TRX4 Trail Crawler models. Machined from 6061 T6 aluminum with CNC engraving and a polished finish, the pieces offer a durable, low-profile attachment for bumper mounting and visual detail on scale bumpers.

Installation is straightforward for typical scale bumpers: align a D-ring with the bumper mounting point and secure using the included screw pins. The kit includes the hardware shown in the product notes for direct attachment to existing bumper holes; verify thread type and hole spacing on your bumper before fitting.

In tuning and setup, these D-rings act as decorative anchor points and modest recovery attachment spots for scale operations on a crawler model. They add visual realism and provide a convenient tie-down point during transport or light recovery tasks within RC scale use, while remaining an accessory-level item rather than a load-bearing component for heavy pulls.