TRAXXAS TRX4 Trail Crawler Brass Front Bumper Mount by GPM TRX4331FXA  [TRX4331FXA]

Brass front bumper mount for TRX4

This brass front bumper mount is an RC-scale accessory designed to stabilise the front bumper and add forward weight on Traxxas TRX4-based trail crawlers. The component serves dual purposes: it secures bumper alignment for a firmer chassis interface, and provides an external counterweight (approx. 200g) useful when tuning front-end balance for crawling or technical trail driving.

The kit includes the brass mount and all steel hardware required for installation. Typical installation places the mount on the vehicle's front bumper assembly using the supplied screws and washers, and in many setups the part allows moving the servo forward slightly to shift the front centre of gravity. Use it as part of a measured tuning approach rather than as a substitute for proper chassis setup.

• Includes: Brass bumper mount - 1pc
• Includes: Stainless steel flat head screw 3x12 - 4pcs
• Includes: Stainless steel round head screw 3x8 - 4pcs
• Includes: Alloy counter sink washer 3mm - 4pcs
• Includes: M4x2.5x14.5 screw shaft - 2pcs

This is a purpose-built brass accessory for TRX4-scale models to help stabilise the front end and allow incremental ballast tuning during trail crawling setups.