TRAXXAS TRX4M FORD BRONCO Brass Front C-Hub Set by GPM TRX4M019X  [TRX4M019X]

Brass Front C-Hub for TRX4M

This is an RC-scale front C-hub assembly designed for TRAXXAS TRX4M platforms, produced as an aftermarket replacement by GPM. The unit is CNC machined from solid brass and positioned between the front gearbox and the front C-hub to integrate with the full steering assembly. Its mass and geometry are intended to act as a counterweight consistent with the original OP part, contributing to steadier low-speed crawling behavior without affecting non-RC systems.

The middle connection uses a 3x6x2.5 bearing to interface the CVD, replacing a gasket-style connection used in the original part. That bearing-mounted interface provides a smoother rotation and reduced localized wear between the CVD and hub compared to the original gasket solution. Each brass piece is specified at approximately 4g, providing measurable added weight at the wheel end for tuning roll and traction characteristics.

Use this brass front C-hub when you need a durable, bearing-supported hub that adds weight at the front axle for improved crawl stability and a smoother CVD connection in TRX4M scale builds.