TRAXXAS TRX6 MERCEDES-BENZ Aluminum Hex Adapters 12mm Thick - 30pc set by GPM TRX6010/12MM  [TRX6010/12MM]

Aluminum hex adapters for TRX6

This is an RC-scale aluminum hex adapter set produced for TRAXXAS TRX6 MERCEDES-BENZ applications, intended to alter wheel offset and tighten the gap between hub and rim. The adapters are machined from 6061 T6 aluminum and increase hex thickness to 12mm, positioned closer to the wheel to change track width without modifying axle or wheel cups.

Installation is straightforward for hobbyists familiar with wheel and drive assemblies: remove the stock hex, fit the adapter onto the wheel hub, secure with the included stainless fasteners and shims, and reassemble the wheel to the CVD or drive shaft. The kit is designed for use with the model's front CVD and rear drive shaft and wheels, and works as a tuning component to fine tune handling by adjusting wheel placement.

Because this is an aftermarket RC accessory, check physical clearance at the suspension and body mounts before final use. Use correct torque on stainless screws to avoid deforming the aluminum hex, and verify wheel balance after installation when changing offset significantly.