TRAXXAS UNLIMITED DESERT RACER stainless steel front turnbuckle set for steering 6pcs by GPM UDR162SA  [UDR162SA]

Front steering turnbuckle set for TRAXXAS UDR

This is an RC-scale front steering turnbuckle set produced for TRAXXAS UNLIMITED DESERT RACER users, supplied by GPM under model UDR162SA. The set is intended to assist the knuckle arms in completing the steering motion by providing adjustable, threaded tie rods with ballend interfaces that match the steering geometry.

Materials and function: the turnbuckles use 304 stainless steel for corrosion resistance and rigidity, the tie rods are adjustable by rotating the body clockwise or counterclockwise to change length, and the ballends are shaped with a specific angle to fit the factory steering knuckles. The hardware layout helps maintain consistent steering geometry while allowing incremental alignment and toe adjustments.

Included items and fit: the package forms a 6 pcs set suitable for front steering linkage on the TRAXXAS UNLIMITED DESERT RACER platform, consisting of 2 stainless steel turnbuckles, 2 stainless steel round head screws 3x20, and 2 stainless steel round head screws 3x16. Use the supplied screws where the original mounting points accept those sizes.

Installation and tuning notes: install the turnbuckles between the steering bellcrank/servo linkage and the steering knuckles, secure ballends into the knuckle and bellcrank, then set initial lengths with the turnbuckles roughly equal on both sides. Make fine adjustments by rotating the turnbuckle bodies to remove steering trim and set toe; verify endplay and binding through the full steering throw. Check screw tightness after a few runs.