TRAXXAS X-Maxx 1/8 +1mm Aluminium Wheel Hex Claw by GPM TXM006/+1  [TXM006/+1]

Wheel hex claw for X-Maxx

This aluminium wheel hex claw is made for TRAXXAS 1/8 X-Maxx applications and supplied as a pair, providing a +1mm offset to alter wheel fit and engagement. The part is presented as a direct replacement hex claw designed to interface with standard X-Maxx hub assemblies while keeping the upgrade focused on wheel positioning and clamping integrity.

Use the claw where a small change in offset helps clear tyre rub, improve wheel seating with aftermarket rims, or fine-tune track width for handling balance. The aluminium construction prioritizes dimensional stability and wear resistance compared with common plastic hexes, helping maintain a consistent wheel mount under load.

Installation follows standard wheel removal and reinstallation steps: remove the wheel and the existing hex, fit the aluminium claw onto the hub, confirm flush seating, then refit the wheel and secure per original factory practice. After installation, verify wheel runout and wheel retention during a short test run before regular operation.

For builders and tuners running TRAXXAS X-Maxx, this +1mm aluminium hex claw offers a compact way to adjust wheel fit and durability without changing hub assemblies, making it a practical part for wheelset upgrades and fitment checks.