TRAXXAS X-Maxx 1/8 Aluminium Shims & Stainless Steel Screws by GPM TXM007  [TXM007]

X-Maxx 1/8 shim and screw set

This aftermarket set is produced by GPM for the TRAXXAS 1/8 X-Maxx platform and contains aluminium shims alongside stainless steel screws intended for RC-scale tuning and maintenance. The components are meant for fine adjustment where thin spacing or corrosion-resistant fasteners are required in a hobby model chassis.

Shims are commonly used to adjust mesh, preload, and lateral alignment on axle, gearbox, and suspension interfaces. Stainless steel screws provide a durable alternative to standard hardware where thread strength and rust resistance matter after frequent outdoor runs. The set is designed to integrate with the X-Maxx assembly points without changing primary geometry.

Installation notes: use appropriate-sized hex drivers and avoid over-torquing; place shims incrementally to achieve the desired clearance before final tightening. Check mating faces for burrs and keep fasteners snug but not stress-loaded to preserve bearing and gear life.