TRAXXAS X-MAXX Rear wheel hex claw +3mm with brake disk by GPM TXM006R/DISK  [TXM006R/DISK]

Aluminium rear hex claw for X-MAXX

This aluminium rear wheel hex claw with integrated brake disk is produced by GPM for TRAXXAS X-MAXX users who need a compact, rigid mounting point for rear wheels. The part provides a fixed +3mm offset and a machined brake-disk surface to help keep wheel and tyre alignment consistent under drive loads typical of large-scale RC running.

The component is an RC-scale accessory designed to replace standard plastic hexes. Its aluminium construction reduces flex where the wheel seats on the hex, offering improved repeatability when you change tyres or run at higher motor power. The integrated brake-disk face is intended as a mounting/locating surface and does not alter your vehicle's existing braking system setup.

Installation notes: the piece fits as a direct rear-wheel hex for TRAXXAS X-MAXX specification hubs and uses the same retention method as factory hexes. Use the correct hex screw size and torque to avoid stripping wheel studs, and check wheel runout after installation. Because this is a machined metal part, inspect mating faces and thread interfaces regularly and use thread locker where the drivetrain manual recommends it.

For hobbyists tuning X-MAXX rear-end behaviour, this aluminium hex claw offers a low-profile, stiffer wheel mounting with a +3mm offset option to fine-tune wheel stance and stability without changing hub geometry.