TRAXXAS X-MAXX 1/10 Stainless Steel+Aluminum Upper Support and Upper Arms by GPM TXMW054FRS  [TXMW054FRS]

Upper support and upper arms for X-MAXX

This RC-scale supporting mount set replaces the front and rear upper arm assemblies on TRAXXAS X-MAXX platforms and is intended for hobby use only. The kit is an adjustable aftermarket hop-up that combines stainless steel pins with aluminum mounting parts to increase structural stiffness while limiting added weight. It is supplied to let builders fine-tune suspension length and wheel angle for different track and terrain setups.

The arms are adjustable: loosen the mounting screws, insert a pin or an Allen key into the adjuster, and rotate to extend or retract the link length. Adjustment changes suspension geometry and wheel toe/camber tendencies, allowing incremental setup changes without replacing fixed-length links. The item is suitable for either front or rear upper arm positions as noted by the part location.

Installation notes: this set fits RC-scale MAXX models listed in the compatibility section, uses the supplied stainless steel pins and flat head screws for mounting, and is intended to be used with standard RC tools. Confirm fitment on your chassis before final assembly and check torque on stainless fasteners to avoid thread damage in aluminum mounting points.

As an aftermarket set for TRAXXAS X-MAXX RC platforms, this stainless steel and aluminum supporting mount with adjustable upper arms offers a practical way to tune suspension geometry for varied track conditions while maintaining RC-scale weight control and durability.