TRAXXAS X-MAXX Steel #45 Dogbone 3pcs by GPM TXM1160S/1  [TXM1160S/1]

Steel #45 Dogbone for Traxxas X‑MAXX

This is an RC-scale aftermarket dogbone set designed for TRAXXAS X‑MAXX platforms, supplied by GPM as TXM1160S/1. The parts use steel #45 construction and are intended to give a stiffer driveshaft option compared with standard-diameter dogbones.

Key dimensions reported by the source: the dogbone shaft diameter increases from 5.5mm up to 7mm across the section to resist bending under heavy loads, and the pins at the dogbone ends are specified at 3.5mm in diameter. The set as provided includes 1 pcs 3.5-thread steel collar and 1 pcs 3.0x20 steel pin alongside the dogbones.

Use and tuning notes: this upgraded steel dogbone is intended for rough off-road and rally-style RC driving where a thicker shaft helps reduce deformation and improve drivetrain stability. Check hub and axle bore clearances on your X‑MAXX before installation, confirm the 3.5mm pin fitment, and inspect retention hardware after initial runs to ensure no interference with suspension travel or bearings.