TRAXXAS Xo-1 Aluminium Wheel Hex Claw (0mm) by GPM XO006  [XO006]

Aluminium wheel hex claw for XO-1

The GPM XO006 aluminium wheel hex claw is an RC-scale replacement part designed to interface with TRAXXAS Xo-1 wheel hubs. Supplied as a pair, these machined aluminium hex claws maintain a 0mm offset and serve as a direct-fit component for wheel retention and alignment on XO-1 chassis assemblies.

Fitment and installation are straightforward for hobbyists familiar with wheel hub assemblies: remove the wheel and original hex, confirm hub seating and bearing condition, then press or screw the aluminium hex claw into the hub per factory hardware orientation. Use the correct hex screw torque and verify runout after installation to avoid misalignment.

In tuning and maintenance contexts this part functions as a wear replacement and a precise mounting interface. The aluminium construction provides consistent geometry for wheel mounting, which is useful when checking toe, camber, and wheel balance during setup or after crash repairs.

This XO006 hex claw is provided for RC-scale wheel mounting on TRAXXAS Xo-1 chassis where a 0mm offset aluminium hex is required, use standard hub hardware and check fitment before track use.