TRAXXAS XO-1 Rear CVD Drive Shaft Stainless Steel 304+Aluminum by GPM SXO1277RHA  [SXO1277RHA]

Rear CVD drive shafts for Traxxas XO-1

This is a set of rear CVD drive shafts designed for Traxxas XO-1 scale RC use, built to reinforce the link between the rear gearbox and the wheels. The assembly uses 304 stainless steel for the axle joints and 6061 T6 aluminum for the shaft bodies, keeping weight low while improving tensile strength compared with stock plastic parts.

The axle joints are formed so the moving joint is recessed and protected inside the shaft housing, and silicone o-rings are fitted at the joint to reduce shock transferred to the CVD when landing or on hard impacts. The shafts are produced slightly thicker than the factory pieces to extend service life under aggressive driving.

Available in multiple anodized colors on the aluminum bodies, the set is intended as a direct replacement hop-up for XO-1 owners seeking increased durability and cleaner joint protection without changing gearbox geometry.

Use these shafts as direct rear replacements on XO-1 setups to reduce joint wear and improve impact tolerance; verify fit and any necessary small setup changes before track use.