TRAXXAS XRT 8S 7075-T6 Aluminum Battery Hold-down by GPM XRT0126A  [XRT0126A]

Battery hold-down for XRT 8S

This GPM-produced hold-down is an aluminum mounting kit intended for RC-scale use on TRAXXAS platforms. The component uses 7075-T6 aluminum for rigidity and pairs snap-lock style clamps with 3M adhesive foam pads to limit battery movement under acceleration and over rough terrain. The design focuses on secure retention and straightforward installation while leaving battery orientation and tuning choices to the model builder.

Installation is performed using the included flat head screws or the 3M adhesive pads depending on chassis access and builder preference. The snap-lock clamps provide a repeatable clamping point for common 1/6 scale battery packs while the aluminum base resists flex that can let the pack shift. For setup, position the battery to maintain your vehicle's intended centre of gravity and fasten either with screws to existing tapped bosses or with the adhesive pads where screw access is restricted.

Use this hold-down to reduce battery shift in TRAXXAS XRT 8S builds, selecting screws or 3M pads based on chassis access and tuning goals; keep wiring clear of clamp areas during fitment.