XRAY 332085 - Carbon Shock Tower Front - 1 Dot - 2 Positions  [XR-332085]

Front carbon shock tower, 2.5mm

This front shock tower is a CNC-machined RC-scale accessory made from 2.5mm carbon fiber plate, offering a direct replacement or upgrade for kits that use aluminum bulkheads. The layout provides two primary position options and a single dot indexing for consistent setup reference.

Designed with multiple shock upper mounting positions, the part lets you adjust leverage and roll centre characteristics at the front end without modifying bulkhead geometry. The tower's fit is intended for use with aluminum bulkheads, so verify alignment and screw engagement during installation.

In field use, this component supports fine-tuning of front suspension response and chassis balance by enabling small, repeatable changes to shock mounting points. Treat it strictly as an RC-scale part intended for model suspension tuning.

Keep fasteners hand-tight at first, confirm shock eyelet alignment through the full travel, and use the tower's multiple mounting positions to incrementally evaluate handling changes on your 1/10-scale setup.