XRAY 352018 GT Aluminium Front Anti-roll Bar Bulkhead Right for Flat Chassis Swiss 7075 T6  [XR-352018]

Front anti-roll bar bulkhead — right side

This right-side front anti-roll bar bulkhead is intended for GT flat chassis layouts where precise anti-roll bar operation and predictable front-end stiffness are required. The component positions and supports the anti-roll bar bearings to maintain consistent motion under repeated load cycles typical in competitive RC track use.

Machined from Swiss 7075 T6 aluminum, the bulkhead is produced with tight tolerances to ensure a repeatable fit and solid interface with the chassis. Critical bearing areas are reinforced to reduce deformation and preserve anti-roll bar geometry during demanding sessions, keeping roll response predictable lap after lap.

For installation, orient the part on the right side of the front assembly and secure it using the chassis’ existing mounting locations. The bulkhead acts as a structural member affecting front-end rigidity and the anti-roll bar’s effective leverage, so it should be considered as part of ride and balance setup rather than a standalone tuning change.

Use this right-side bulkhead when you need a rigid, precisely located support for the front anti-roll bar on GT flat chassis designs; it is intended to deliver repeatable behaviour and long-term dimensional stability for RC race tuning.