XRAY 352670-G - Servo Ball Joint 5.8mm Graphite (4 pcs)  [XR-352670-G]

Lightweight Graphite Servo Ball Joints

The XRAY 352670-G servo ball joint set delivers a compact, purpose-built linkage end for RC models that use 5.8mm pivot balls. Molded from a specially formulated graphite composite, the four-piece set balances reduced mass with increased stiffness to keep steering linkages precise and responsive.

Each ball joint is shaped to allow free articulation on 5.8mm pivot balls while maintaining consistent geometry under load, which helps reduce play in the steering system and preserves predictable steering feel. The graphite composite surface offers low friction and resists binding when exposed to dust or light contamination.

Installation is straightforward: press each joint onto a 5.8mm pivot ball until fully seated, check for smooth rotation and appropriate endplay, and confirm linkage geometry before final trim or adjustment. As a tuning item, these ball joints are used to reduce slop and to fine-tune steering feedback without adding significant weight.

Contents: set of 4 pcs graphite servo ball joints for 5.8mm pivot balls.