XRAY 355433-XH Front Central Dogbone Drive Shaft 88mm 6° HUDY Pins Hudy Spring Steel  [XR-355433-XH]

Front central dogbone drive shaft

This 88mm front central dogbone drive shaft is an RC-scale drivetrain component machined from Hudy Spring Steel and hardened for wear resistance. Each shaft is CNC-machined, hand-ground for finish accuracy, and inspected individually to meet predictable fit and runout tolerances.

Designed for front central placement in compatible GTX series setups, the shaft uses HUDY hardened pins at a 6° orientation to maintain retention under load. Weight reduction machining removes unnecessary mass without compromising structural integrity, helping reduce rotating inertia in the front drivetrain.

For installation, verify fitment with your vehicle's differential and dogbone interfaces, confirm pin engagement and retaining method, and replace any worn mating dogbones or bearings to prevent atypical wear. As a tuning element, this shaft contributes to sharper front response and consistent drivetrain behavior when combined with matched front axles and bearings.

This component is intended for hobby-grade model car drivetrains where a hardened, lightweight front central shaft is required, offering a balance of reduced mass and long-term durability when installed and maintained correctly.