This 80mm front central dogbone drive shaft is an RC-scale replacement part engineered for the GTXE 2027 platform. CNC-machined from Hudy Spring Steel and hardened for wear resistance, the shaft is weight-reduced where possible while retaining structural strength to withstand typical touring car driveline loads.
Each shaft is hand-ground for dimensional accuracy and individually measured and inspected to keep runout and fitment consistent. HUDY special hardened pins are used for retention, delivering predictable service life under normal RC use.
In tuning terms, the reduced mass and precise machining help lower rotational inertia at the front driveline, which can influence throttle response and handling balance. When installing, ensure correct pin engagement, check for adequate clearance to steering and suspension components, and confirm equal shaft lengths across the front assembly to avoid drivetrain binding.
Choose this shaft when you need a factory-quality, hardened Hudy Spring Steel front central dogbone that balances reduced mass with reliable durability for GTXE 2027 builds and setups.
Copyright © 2008-2026 rcjaz.com All rights reserved
