XRAY NT1 Rear Swing Shaft by 3Racing XN1-14  [XN1-14]

Rear swing shaft for NT1

The XRAY NT1 rear swing shaft supplied as a 3Racing XN1-14 part is an RC-scale replacement component intended for the NT1 touring car chassis. It serves as the pivot axle for the rear swing arms and is used when swapping worn parts or restoring suspension geometry after impacts.

Fit and function: this shaft is intended to integrate with the NT1 rear suspension assemblies and related linkage points, restoring alignment and allowing expected pivot motion without altering factory geometry.

Installation notes: remove the rear bulkhead and swing arm assembly according to your chassis service routine, extract the old shaft, then install the replacement shaft ensuring secure seating in the swing arm bores and correct retaining method for your NT1 setup. Verify free movement and clearances before track use.

Tuning role: replacing a bent or worn rear swing shaft can recover predictable suspension response, helping to maintain consistent rear roll center and damping behavior during setup changes.