XRAY NT1 Titanium Turnbuckle Set by 3Racing XN1-39  [XN1-39]

Turnbuckle set for NT1 chassis

This turnbuckle set is offered by 3Racing for use with the XRAY NT1 chassis. It is an RC-scale suspension and steering linkage accessory made from titanium finish material, intended to replace standard steel or aluminium turnbuckles where compatible. The description here only confirms the part name and its chassis target, please verify fitment against your NT1 components before installation.

Role in tuning: turnbuckles adjust toe, camber link length, and some roll-centre characteristics on touring car setups. Replacing original linkages with titanium-finish turnbuckles provides a stable threaded connection for fine adjustments during setup sessions, helping to keep alignment settings consistent between runs.

Installation notes: ensure thread directions match the left/right locations on the NT1 chassis and use the correct hex driver sized for the existing ball ends and rod ends. Tighten to a firm hand torque to avoid stripping threads, and confirm full range of motion for suspension and steering after fitting. If replacing matched-length links, check pre-load and adjust incrementally while measuring alignment changes on both front and rear axles.

Maintenance and handling: titanium-finish parts resist corrosion better than untreated steel, but inspect threads periodically for wear, and reapply thread-locker sparingly where you need permanent fixation. Keep ball ends and rod ends free of grit to avoid accelerated wear.