XRAY T3'12 rear shock tower 3.0mm graphite by Arrowmax am-t3-303087  [am-t3-303087]

Rear shock tower for XRAY T3'12

This Arrowmax am-t3-303087 rear shock tower is an RC-scale replacement part produced for the XRAY T3'12 chassis, finished in 3.0mm graphite. It serves as the mounting platform for the rear shocks and links, providing a consistent reference point for suspension geometry during setup and tuning.

The component is intended to be a direct swap with the stock T3'12 rear tower, retaining factory mounting locations to preserve baseline suspension geometry. Use this part when you want a straight replacement or when testing changes to rear roll center and shock angle without altering other bulkhead components.

Installation notes: inspect existing mounting hardware and bearings before reassembly, torque fasteners to your chassis specifications, and verify shock lengths and link geometry after fitting to ensure expected ride height and travel. The graphite construction helps keep weight low while maintaining dimensional stability under typical RC touring car loads.