This Arrowmax produced drive shaft set is made for XRAY T3 and T4 chassis and provides a direct replacement for worn or damaged front/rear drive shafts on those platforms. The parts are specified as 52mm length and manufactured from spring steel to maintain flex resistance under load while remaining suitable for typical scale competition and club use.
Installation is straightforward when replacing existing shafts in the XRAY T3/T4 driveline: remove the damaged shaft assembly and refit the Arrowmax units to the corresponding drive cups and differential outputs. The design focuses on part-for-part fitment so chassis geometry and driveline spacing are preserved without additional modification.
From a tuning perspective these shafts are a basic hop-up for durability and drivetrain consistency. Use them when diagnosing vibration, binding, or excessive wear on factory shafts, or when preparing a car for repeated track sessions where material fatigue can accumulate.
A straightforward aftermarket replacement for XRAY T3/T4 users seeking a durable 52mm spring steel shaft pair to maintain driveline reliability and consistent setup behaviour.
Copyright © 2008-2026 rcjaz.com All rights reserved
