XRAY T4 52mm BB DJC Drive Shaft by Arrowmax AM-010084  [AM-010084]

XRAY T4 52mm drive shaft

This Arrowmax AM-010084 drive shaft is an RC-scale replacement part specified for the Xray T4 touring chassis, supplied as the BB DJC bone-only shaft in spring steel and 52mm length. The listing denotes the shaft only, without additional linkage or hardware components.

Use this shaft where a direct, like-for-like replacement is required during maintenance or when swapping worn drivetrain bones. Spring steel construction is intended for parts that experience repeated torsional load; in practice this part serves as a straightforward swap to restore drivetrain geometry and maintain consistent power transfer on a T4 chassis.

Installation notes: this is a component-level replacement for the T4 drive assembly. Remove the existing bone, inspect mating cups and pins for wear, and replace any associated fasteners or bearings as needed to retain proper alignment. Small fit adjustments and trial runs are recommended after installation to confirm free rotation and absence of binding under normal load.