XRAY T4 52mm Drive Shaft Set by Arrowmax AM-010051  [AM-010051]

Drive shaft set for XRAY T4

The Arrowmax AM-010051 ECS Drive Shaft Set V2 is a pair of 52mm spring steel drive shafts produced for use with the XRAY T4 chassis. Supplied as two pcs, the V2 geometry is intended to directly replace the stock 52mm shafts without alterations to the chassis layout when used on compatible T4 setups.

These drive shafts are specified as spring steel, giving a balance of toughness and fatigue resistance appropriate for drivetrain replacement parts. In practical terms they serve as direct spares for worn or damaged shafts and can be used during setup changes where consistent shaft behavior is required across runs.

Installation is straightforward for users familiar with XRAY T4 maintenance: the shafts install into the gearbox/differential assemblies in place of the original 52mm items and use existing retention methods and bearings. No special machining or rework of the chassis is indicated by the product designation; verify fit with your vehicle before final assembly.

For tuning, these shafts are a drivetrain component choice that affects rotational mass and connection stiffness. When evaluating handling changes after swapping shafts, test under controlled conditions and compare lap times or telemetry to isolate shaft effects from other setup variables.

A straightforward replacement set for XRAY T4 owners who require 52mm spring steel shafts, intended as direct spares and tuning components within the drivetrain.