XRAY T4 53mm BB DJC bearing block by Arrowmax AM-010071  [AM-010071]

BB DJC bearing block for XRAY T4

This Arrowmax AM-010071 BB DJC accessory is a 53mm-scale bearing block intended for use on XRAY T4 chassis setups. It is an RC-scale part designed to interface with 53mm linkage layouts and to replace or upgrade an existing ball joint block where the BB DJC form factor is required.

The block's role is functional and tuning-oriented: it locates ball ends, maintains linkage spacing, and can affect steering geometry and roll-center behavior when swapped during setup changes. Confirm the 53mm dimension on your XRAY T4 linkage before installation to ensure correct fitment.

Installation is straightforward for users familiar with typical T4 linkage hardware: remove the existing block, transfer any necessary studs or bearings, and secure fasteners per your chassis setup. No special tools are required beyond standard hex drivers used for T4 maintenance. After fitting, verify free movement through the steering sweep and recheck geometry settings.

Use this BB DJC block when matching 53mm linkage geometry on XRAY T4 cars; treat it as a precision replacement part within normal RC setup workflows and verify clearances after changeover.