XRAY T4 Front Graphite Shock Tower 3.0mm by Arrowmax AM-T4-301960  [AM-T4-301960]

Front graphite shock tower for T4

This Arrowmax AM-T4-301960 front shock tower is an RC-scale graphite replacement part designed for XRAY T4 series cars. The 3.0mm graphite plate increases front bulkhead rigidity and provides a firmer mounting point for the shock absorbers, helping to stabilise suspension geometry during high-load cornering.

The tower suits hobbyists who tune chassis flex and front-end response. It installs using the same mounting holes as the stock tower on compatible T4 layouts, so no additional hardware is required beyond the original screws and spacers. When fitting, check preload and shock angle, as the increased stiffness can change ride feel and traction balance.

Tuning notes: use the 3.0mm tower when you need reduced chassis flex for quicker steering response on high-traction surfaces, and revert to thinner towers to regain bite on low-traction layouts. Combine with careful shock valving and spring selection to maintain predictable handling.