Yokomo B10-301SA Aluminum separate NA rear suspension mount (Front) for BD10  [B10-301SA]

BD10 rear suspension front mount

This is an aluminum separate NA rear suspension mount intended for the front side of the rear suspension on BD10-scale touring car chassis. The part is an RC-scale accessory designed to replace the stock plastic mount with a machined aluminum unit to provide a firmer mounting point and a consistent reference for suspension setup.

Fitment targets the BD10 family of chassis variants listed below. The component’s role in setup is focused: it stabilizes the upper/lower mounting geometry at the rear, allowing small adjustments to roll center and arm positions when used alongside standard BD10 suspension pieces. Installation typically requires removal of the original mount and reuse of the factory hardware where compatible.

This article emphasizes compatibility and tuning function rather than styling. Verify fit against your existing BD10 rear bulkhead and hardware before installation, and use appropriate hand tools to avoid overtightening aluminium threads.

Use this aluminum front-side rear suspension mount when you need a stable, repeatable rear suspension pivot point on BD10 variants; pair it with verified hardware and check suspension geometry after installation.