This aluminum rear stiffener is an RC-scale accessory designed to increase rigidity at the rear of BD10-series on-road chassis. The part changes the rear rigidity balance depending on where it is mounted and how many screws are used, offering a straightforward way to fine-tune rear flex without altering suspension geometry.
Installation uses the rear mounting area and existing screw locations on the BD10 variants listed in the specifications, allowing installers to experiment with different positions and screw counts to influence understeer/oversteer tendencies and traction feel on track. The tone is technical and neutral, focused on fitting and tuning duties rather than promotional claims.
This component is useful when testing chassis stiffness settings during setup sessions, helping to isolate whether handling changes come from chassis flex or suspension adjustments.
As an aluminum rear stiffener for BD10 variants, this part provides a tunable approach to rear chassis rigidity that complements suspension and tyre setup adjustments.
Copyright © 2008-2026 rcjaz.com All rights reserved
