Yokomo B8-413GH Hard front steering hub carrier for BD8 (graphite molded)  [B8-413GH]

Front steering hub carrier for BD8

The Yokomo B8-413GH is a hard-type front steering hub carrier molded with a graphite-containing resin compound designed for BD8 series touring cars. The material choice increases component rigidity compared with standard plastic carriers, with the stated effect of sharpening steering response and helping maintain stability during higher-speed cornering.

This item is supplied as one piece for each side, left and right. Fitment is targeted at BD8-compatible platforms; confirm chassis code before installation. The carrier replaces the stock front hub carrier to alter the steering behaviour and front-end feel without changing suspension geometry.

Installation notes: the part mounts in the same location as the original BD8 front hub carrier and uses existing fasteners and bearings from the standard assembly. Check alignment and bearing preload after installation, and verify no interference with servo horn or tie-rod travel before running.

Tuning role: swapping to this harder, graphite-reinforced carrier can reduce flex under steering loads, yielding crisper initial turn-in and more predictable behavior through sustained cornering. Use it as part of a front-end setup progression alongside tyre choice and suspension adjustments to refine turn-in and mid-corner balance.