This is a hard-type graphite molded rear hub carrier designed for the optional RTC (rear toe control) system on the BD8 2018 chassis. Manufactured as an RC-scale replacement or hop-up part, the component is intended to provide a stiffer mounting point for the rear suspension knuckle where toe adjustments are managed by the RTC assembly.
In practice the part changes the compliance at the rear hub carrier compared with softer resin pieces, which can affect how quickly toe reacts under load and during direction changes. Keep in mind this is a chassis-level tuning component for on-road 1/10 vehicles and should be considered alongside sway, dampers, and toe-in settings when refining handling.
Installation is straightforward for builders familiar with BD8 maintenance, the carrier replaces the stock RTC-compatible rear knuckle, and requires standard wheel hub hardware and bearings already used on the chassis, no special tools beyond common hex drivers are needed. Check fit and free play before running, and verify rear toe symmetry after assembly.
Copyright © 2008-2026 rcjaz.com All rights reserved
