Yokomo BD-010AW Front/Rear Axle for Double-Joint CVD compatible with BD7 and BD5  [BD-010AW]

Front/Rear Axle for Double-Joint CVD

This BD-010AW axle is an RC-scale replacement part intended for the double-joint universal inboard CVD assemblies used on BD7 and BD5 platforms. Use it when an existing axle shows wear, play, or visible damage, or when performing routine repairs that restore drive linkage integrity.

Supported chassis include: MRTC-BD716 / MRTC-BD716H / MRTC-BD716O / MRTC-BD716S / MRTC-BD7RS / MRTC-BD715B / MRTC-BD715O / MRTC-BD715S / MRTC-BD7RS2 / MRTC-BD7RS3S / MRTC-BD8 / MRTC-BD8A / MRTC-BD8-P / MRTC-BD8AP / MRTC-BD8SV / MRTC-BD818A / MRTC-BD818.

Installation and tuning role: this axle replaces the inner shaft that connects the double-joint CVD to the differential output, so it directly affects alignment and driveline feel. When installing, inspect CVD cups and cross pins for wear, verify there is no excessive endplay in the CVD housings, and confirm smooth rotation through the suspension travel. Proper axle condition helps maintain predictable throttle and steering response during track setup.

Maintenance tips: check for nicks, bends, or looseness at the joint ends, and replace the axle if you detect binding or excessive play. Keep mating surfaces and bearings clean, and recheck after initial test runs following any replacement.