This aluminum sway bar holder secures the stabilizer on Yokomo BD5 chassis variants. The part is blue anodized which provides corrosion resistance and a consistent finish for chassis dress-up without affecting function.
Installation is straightforward: replace the factory holder or add this unit where the stabilizer mounts, align the stabilizer link and tighten the set screws. Apply thread locking compound to the set screws to reduce the risk of loosening under vibration.
Functionally this holder keeps the sway bar locating points rigid and repeatable, helping you tune roll balance and transient responses during set-up sessions. Use common tuning steps for sway bars when adjusting stiffness and link positions on the BD5 platform.
Copyright © 2008-2026 rcjaz.com All rights reserved