Yokomo BD-415A00 Aluminum rear hub carrier 0 degree for BD7/BD5  [BD-415A00]

Yokomo BD-415A00 Aluminum Rear hub carrier 0degreefor bd7/BD5
Price:
USD$14.00
Brand:
Yokomo
Model:
BD-415A00
GTIN:
3888
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - BD5 category
Write a review

Aluminum rear hub carrier for BD7/BD5

This BD-415A00 rear hub carrier is an aluminum replacement part for scale RC touring chassis, designed to match the stock 0° toe-in geometry while increasing rear-end rigidity compared with the original component. The part is intended to be used on RC touring cars to influence handling balance and cornering response without changing the basic toe setting.

Installation notes: this carrier replaces the stock rear hub carrier and uses the same mounting points and hardware locations as the original 0° unit. Check fitment on your suspension arm mounts and confirm wheel hex alignment before final tightening. Use thread locker where appropriate and torque fasteners to your chassis manufacturer’s recommendations.

Tuning role: the 0° carrier preserves the standard toe-in while raising lateral stiffness at the hub, which can reduce rear compliance under load and make high-speed cornering feel more predictable. For different handling outcomes, pair this 0° carrier with other carrier angles and arm mounts to explore toe and roll-center combinations on track.

Packing includes

  • Aluminum rear hub carrier - 2 pcs

Compatibility

  • DP-DIB2
  • DP-DIB2R
  • DP-DIB2A
  • DP-DIB2RA
  • DP-DIB
  • DP-DIBR
  • DP-DIBG
  • DP-DIBRS
  • DP-DIBL
  • DP-DIBLR
  • DP-DIBLG
  • DP-DIBRSB
  • MRTC-BD7RS
  • MRTC-BD715B
  • MRTC-BD715O
  • MRTC-BD715S
  • MRTC-BD716
  • MRTC-BD716H
  • MRTC-BD716O
  • MRTC-BD716S
  • MRTC-BD7RS2
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is this carrier a direct replacement for the stock BD7/BD5 rear hub carrier?

Yes, the BD-415A00 uses the same mounting points and 0° toe geometry as the stock rear hub carrier for the listed chassis.

Will installing this part change rear toe settings?

No, this 0° unit maintains the stock toe-in; any toe change requires swapping to a different angle carrier or adjustable mounting hardware.

Any installation tips to ensure correct alignment?

Verify suspension arm orientation, confirm wheel hex engagement, and tighten fasteners progressively while checking wheel toe and roll alignment.

Copyright © 2008-2026 rcjaz.com All rights reserved