Yokomo B-MAX2 Front Upper Arm Mount by Arrowmax AM-MAX2-017  [AM-MAX2-017]

Front Upper Arm Mount for B-MAX2

This Arrowmax AM-MAX2-017 front upper arm mount is an RC-scale replacement part made from 7075-T6 aluminium with blue anodized finish. It is produced to replace the original plastic component on Yokomo B-MAX2 chassis without altering suspension geometry.

Designed to reduce flex and improve repeatability, the machined mount fits the standard front upper arm location and works with existing suspension hardware and ball studs used on B-MAX2 setups. The part supports setup work where consistent steering response and reduced component deformation are required during track sessions or practice.

Installation is straightforward: remove the original plastic mount and swap in this aluminium unit, reusing the same mounting screws. When tuning, note that the stiffer aluminium part can change transient feel, so check toe and camber after fitting and re-tighten hardware to the manufacturer's torque preferences.

As a direct aluminium replacement for the factory plastic part, this mount is intended for hobbyists tuning Yokomo B-MAX2 cars who need improved stiffness and longer-lasting suspension attachment points.