Yokomo D-035A Front universal shaft for DRIFT PACKAGE short suspension arm, assembled front L.F. shaft (2mm pin)  [D-035A]

Front L.F. universal shaft overview

This Yokomo D-035A front universal shaft is an RC-scale replacement part designed for drift package short suspension arms. It ships fully assembled and specifies a reinforced joint pin of 2mm diameter, allowing immediate fitting without subassembly. The part is intended for use on DP-series drift chassis and contributes to consistent steering input and predictable front-end behaviour during drift tuning.

Installation is straightforward for hobbyists familiar with short suspension arm setups: remove the original shaft from the L.F. hub, inspect retaining hardware, slide the D-035A shaft into place and secure with the original mounting pins. Because the unit is assembled, preparatory steps are limited to cleaning mating surfaces and confirming pin retention and range of motion through the steering linkages.

In tuning terms this front universal shaft serves as a wear-replacement and a durability upgrade for drift setups that subject front joints to lateral stress. Use it when you need a direct swap to restore steering fidelity or when you want a consistently pre-assembled joint during frequent setup changes on the bench or at the track.

Choose this D-035A shaft when you need a ready-to-fit front L.F. replacement for DP-series drift chassis to maintain consistent front steering response during drift setup and testing sessions.