Yokomo D-041A F & R Bone for Universal shaft 2pin Deep rim  [D-041A]

Universal 2mm 2‑pin drift bone

This is an RC-scale universal bone designed for front and rear use with deep‑rim universal shafts where a reinforced 2mm joint pin is required. It is intended for drift setups and compatible with a wide range of Yokomo DP and MRTC drift chassis as listed below. The component is a drivetrain coupling piece for model cars and should be treated as a scale hobby accessory.

Install with the correct 2mm reinforced joint pins only, verify pin seating and rotation clearance, and confirm spline alignment before final tightening. When servicing, check the joint pins for wear and ensure mating shaft surfaces are clean to avoid binding in the deep rim assembly.

Tuning role: this bone keeps universal shaft coupling geometry consistent during high articulation and drift duty, helping maintain predictable drivetrain response and reducing slop when fitted correctly in the listed chassis.