Yokomo D-127L Aluminum Steering Bell Crank (L) for DP-DPR  [D-127L]

Left aluminum steering bell crank (L)

This is the left-side aluminum steering bell crank intended for the Drift Package DPR family of chassis. It is an RC-scale replacement part that serves as the left steering bell crank in the steering linkage between the舵機 and tie rods on compatible DPR-series models.

Compatibility is limited to the DP-DPR chassis and units explicitly listed as supported, specifically DP-DPMS and DP-DPRA. Use only on model vehicles and measure fitment against the original part before final installation.

Installation is straightforward for those familiar with DPR-series steering assemblies: remove the original left steering bell crank, verify alignment with the舵機 output arm and steering linkage, and fit the D-127L in the same orientation as the factory component. Check existing走珠軸承 and fasteners for wear and tighten to the vehicle's recommended torque using appropriate六角螺絲 tools.

In tuning contexts the D-127L acts as a direct left-side replacement and is part of the steering geometry chain; swapping it during setup or repair can simplify symmetry checks and allow consistent baseline measurements when adjusting steering throw or toe on DPR-series drift cars. It is neutral in design and intended as a service or tuning component rather than an upgrade claim.