Yokomo D-128R Aluminum Steering Bell CrankR for DP-DPR right side steering bell crank  [D-128R]

Yokomo D-128R Aluminum Steering Bell CrankR for DP-DPR
Price:
USD$8.00
Brand:
Yokomo
Model:
D-128R
GTIN:
3888
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - DP-DPRA category
Write a review

Right-side steering bell crank

This part is the right-side unit of the standard aluminum steering bell crank used on the Drift Package DP-DPR chassis. It is an RC-scale replacement component machined from aluminum with an anodized surface for corrosion resistance and consistent fit at the steering pivot.

Use this bell crank when you need a direct replacement for the right steering arm on DP-DPR setups or when swapping parts between the supported DP series variants. It maintains factory mounting geometry so it fits the same mounting points as the original right-side aluminum bell crank.

Installation notes: the part is intended to use the chassis' existing hardware and mounting pattern; check overall steering linkage alignment after fitting and verify pivot play at the axle and bell crank interface. In tuning terms, replacing a worn plastic or damaged bell crank with an aluminum unit can stabilise steering input and keep geometry consistent during drift runs.

Compatibility

  • DP-DPR
  • DP-DPMS
  • DP-DPRA
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is this bell crank for the right side only?

Yes, this D-128R item is the right-side steering bell crank and is shaped to match the right pivot geometry.

Will it fit my DP-DPMS or DP-DPRA chassis?

It is compatible with DP-DPMS and DP-DPRA as listed, sharing the same mounting pattern as the DP-DPR right-side bell crank.

Do I need new hardware to install it?

Typically no; the part is designed to use the original chassis hardware, but always confirm fit and torque settings after installation.

Copyright © 2008-2026 rcjaz.com All rights reserved