Yokomo D-156P Hinge Pins for DPR Upper A Arm  [D-156P]

Hinge pins for DPR upper A arm

This RC-scale hinge pin set replaces the pins used inside the front upper A arm of DPR chassis. The pack contains 2 pcs intended as direct replacement pieces for wear or damage in the upper arm pivot area.

Compatibility is limited to the DPR variants listed below, and the part's role is strictly to restore secure pivoting and consistent suspension geometry at the front upper A arm. Replacing worn pins helps preserve alignment and predictable suspension movement during setup and track use.

Installation overview: remove the upper A arm from the chassis, slide out the old pins, position any bushings or spacers as originally fitted, and insert the new pins until properly seated. After installation, cycle the suspension through its travel to verify smooth movement and secure retention; replace if excessive play remains.