Yokomo FA-19219 FANTOM motor sensor board replacement for HELIX and ICON series  [FA-19219]

FANTOM motor sensor board replacement

This replacement sensor board is intended for the FANTOM motor family and fits motors designed for a 26mm rotor. It provides the sensor interface needed for sensored control when used with HELIX, HELIX V2, ICON V2, ICON V3 and ICON-Torque motor variants. The board's role is to restore or maintain sensored feedback to the motor control system rather than change motor mechanical characteristics.

Installation requires matching the board to the motor variant and aligning connector pins to the motor harness; confirm part orientation and connector type before powering the system. Because this is a component-level replacement, inspect contacts, solder joints and the mating connectors on both motor and ESC prior to full reassembly. Use a static-safe work area and avoid bending sensor leads.

In tuning terms, the sensor board itself does not alter power or timing parameters but ensures the motor retains precise rotor position feedback used by sensored ESC setups. If issues persist after replacement, verify ESC sensor settings and motor timing rather than assuming a mechanical fault.

Use this board when replacing a failed sensor module in a sensored FANTOM motor setup to restore reliable rotor position feedback; pair the swap with a sensor test and ESC configuration check to confirm system operation.