Yokomo MD-DHA-3 Aluminum Diff Height Adapter (L/R) for Master Drift MD3.0  [MD-DHA-3]

Aluminum Differential Height Adapter (L/R)

This MD-DHA-3 unit is an aluminum differential height adapter supplied as left and right pieces for the Master Drift MD3.0 platform. It is intended for 1/10 drift chassis updates where small changes in differential mounting height are used to adjust handling balance and traction behavior.

The adapter set is compatible with the MDR-030 family of chassis and is made to replace or supplement existing diff mounts to change the relative height of the differential case. Because it is machined from aluminum, it provides a stable mounting surface and resists compression compared with softer materials.

Installation is straightforward for experienced model tuners: remove the diff from the chassis, fit the left and right adapter pieces to the diff housing or chassis mounting points as required, and secure using the original mounting hardware. Verify chassis geometry after fitting and re-check fastener torque after a short test run.

Tuning role: altering diff height affects driveline angle and can subtly change steering response and throttle grip in drift setups. Use the adapters to experiment with incremental changes, testing one variable at a time so handling differences are clear.

If you plan iterative setup changes, keep a log of diff height positions and lap feedback; the MD-DHA-3 lets you make repeatable adjustments without changing the diff internals.