Yokomo SD-018GB Graphite rear shock tower — Rear shock tower for drift chassis  [SD-018GB]

Rear shock tower for drift chassis

This is an RC-scale graphite rear shock tower intended for drift chassis use and suspension tuning on Yokomo drift platforms and similar setups. The component focuses on providing a stiffer mounting point for the rear shocks to influence roll centre and damping feedback without altering core chassis geometry.

Installation notes: confirm your chassis' rear tower mounting pattern before fitting, use the vehicle's existing mounting holes and hardware or equivalent fasteners, and verify alignment and thread engagement during reassembly. No attempt is made here to list included fasteners or exact hole spacings; check the part against your car before installation.

Tuning role: swapping a stock plastic tower for a graphite unit changes stiffness at the shock mount, which can reduce flex and sharpen rear response. Use this tower as one element in a controlled setup process alongside shock valving, spring rate, and anti-roll adjustments to achieve the desired drift behaviour.