Yokomo SD-207A Tie Rod Set for RTD fixed-length linkage kit  [SD-207A]

Fixed-length drift linkage

This Yokomo SD-207A tie rod set is a fixed-length linkage kit designed for RTD-style drift setups on 1/10-scale RC drift chassis. The upper arm geometry is preset so the camber sits at approximately 3 degrees, providing a consistent baseline for cornering behaviour without on-track adjustments to arm length.

The set is intended as replacement or spares for compatible DP-series chassis and focuses on maintaining stable toe and camber relationships when using standard drift suspension layouts. As a scale accessory, it helps tune handling by setting a repeatable static camber across front and rear suspension points.

Set contents

• Front Upper Arm L - 1 pcs
• Front Upper Arm R - 1 pcs
• Rear Upper Arm L - 1 pcs
• Rear Upper Arm R - 1 pcs
• Tie Rod - 2 pcs
• Servo Rod - 1 pcs

Installation notes: install as direct replacements for the original arms and tie rods, confirm full thread engagement on ball studs, and verify wheel alignment on a setup stand before running. Because lengths are fixed, use these parts to establish a known baseline for camber and steering response, then fine-tune suspension and tyre choices to achieve the desired drift balance.