This rear hub carrier is a direct replacement part intended for drift-package RC models. It provides the specified 1 Degree orientation used in drift setups and is supplied as left and right units so damaged or worn carriers can be swapped without modifying the axle or upright geometry.
Fitment is model-specific and depends on the chassis listed below. Installation is a straight replacement: remove the damaged carrier, transfer any bearings or spacers as needed, and refit using the original hardware while checking wheel bearing alignment and clearance. Use this part when restoring original geometry or when fine-tuning rear tracking for drift handling.
Copyright © 2008-2026 rcjaz.com All rights reserved