This SD-LW22L extension cord from Yokomo is a simple wiring accessory intended for RC-scale LED installations and other small accessory hookups. The cable uses a 2P to 2P mating arrangement and provides a fixed 150mm lead length to bridge gaps between light units and receiver or power distribution points on the model.
Designed as a wiring convenience rather than an electronic component, the cord lets you reposition LED boards or light units without re-soldering, keeping original connectors intact. When routing the cable, avoid sharp bends and pinches near suspension or steering linkages, and secure the lead with small cable ties to prevent rubbing against chassis parts during running.
Use this extension when you need modest additional reach for LED modules or small sensors, and verify connector polarity before powering the system to protect LEDs and control electronics. The part is an RC-scale accessory compatible with the DP-series chassis listed in the compatibility section below.
Copyright © 2008-2026 rcjaz.com All rights reserved
