Yokomo Y2-018CR Graphite Rear Shock Tower for YD-2 Chassis  [Y2-018CR]

Graphite rear shock tower

The Yokomo Y2-018CR is a graphite rear shock tower intended as an RC-scale hop-up for the YD-2 family chassis listed below. It uses a 3mm high-strength graphite plate to increase structural stiffness while cutting component weight, which helps sharpen rear suspension response and reduces unwanted flex during dynamic maneuvers.

Surface finish is a matte graphite look that resists glare and gives a restrained appearance without altering function. In practice this part is used to tune rear-end feel: increasing tower stiffness shifts suspension behavior toward crisper rebound and more consistent damper action, useful when refining balance between traction and turn-in.

Before fitting, confirm compatibility with your chassis layout and hardware; verify hole alignment and mounting screw lengths match original parts to avoid interference. This item is supplied as a single replacement hop-up component for builders who want a firmer rear mount point without adding unnecessary mass.