Yokomo Y2-304A Aluminum Motor Mount for YD-2  [Y2-304A]

Aluminum motor mount for YD-2

This aluminum motor mount is designed as a direct-fit accessory for the YD-2 family of 1/10 scale drift chassis. It serves as the structural interface that secures the motor in the motor bay and defines motor offset and alignment relative to the spur/pinion or belt drive system. The part is an RC-scale component intended specifically for model chassis use.

Installation is straightforward on supported YD-2 variants using the existing motor mount points on the chassis. Because chassis variations in motor spacing and hardware can exist between DP and MRTC versions, verify the mount alignment and the provided screw holes against your specific chassis before final assembly. The mount replaces the standard plastic bracket with a stiffer aluminum option to reduce flex where the motor is secured.

In a tuning context the mount affects motor positioning stability and repeatability; a rigid aluminum mount helps maintain pinion-to-spur or belt alignment under load and can influence drivetrain feedback during high-slip drifting. When fitting, check mesh or belt tension after installation and recheck after a short test run to confirm no drift in alignment.

Use this Y2-304A mount where a firmer motor mounting solution is needed on YD-2 platforms, confirm hole alignment to your specific chassis variant before tightening, and recheck drive mesh after initial runs.