Yokomo Y2-RAC6 Rear Suspension Mount for YD-2 Series Rear A-arm SP  [Y2-RAC6]

Rear suspension mount for YD-2

This aluminium rear suspension mount is designed for the YD-2 A‑arm SP rear suspension kit and serves as the mounting point between the suspension pins in the rear assembly. The part keeps suspension pin spacing at 38.5mm and maintains a suspension pin angle of 0 degrees, matching the original Y2-RAC design intent.

In practical setup the mount is fitted into the rear A‑arm SP layout where it is used both before and after the rear suspension mount position in the assembly sequence. Because the suspension pin angle is fixed at 0 degrees, rear toe is adjusted exclusively by changing the rear hub angle rather than by rotating this mount.

The component is an aluminium machining intended for RC-scale tuning and chassis alignment tasks on compatible YD-2 platform variants, providing a direct replacement or maintenance part for setups that require the specified 38.5mm pin spacing.

This Y2-RAC6 aluminium rear suspension mount provides the exact 38.5mm pin spacing and a fixed 0 degree pin angle required by YD-2 A‑arm SP rear assemblies, making it suitable where those specific geometry requirements are needed.