Yokomo Y2-RMC-01A Rear motor spacer/Bridge for YD-2  [Y2-RMC-01A]

Rear motor spacer and bridge for YD-2

This part set provides a rear motor spacer and bridge intended for YD-2 scale RC drift chassis layouts. It is an accessory-sized component designed to locate and support the motor assembly at the rear of the chassis, used where a dedicated spacer or bridge is required to achieve proper motor positioning.

Compatibility is stated for YD-2 chassis variants and the supported chassis code DP-YD2RPLS is listed by the source. Confirm this model code against your chassis before installation to ensure fit.

Installation notes: the spacer/bridge mounts to the rear motor area and acts as an interface between the motor mount and chassis. When installing, align the motor so the pinion and spur gear mesh is correct and ensure any factory screws or spacers are reused as needed. Check clearance and rotation before running the motor.

Tuning role: using a rear motor spacer/bridge lets you make incremental changes to motor fore-aft placement, which can influence drivetrain alignment and the chassis balance used in drift setups. Use it as a small tuning adjustment rather than a primary performance upgrade.