Yokomo YOKB2-001WB - Wing mount / Rear bumper (Mid) for B-MAX2 / MR  [YOKB2-001WB]

Wing mount and rear bumper (mid)

This Yokomo YOKB2-001WB component is an RC-scale wing mount and mid-position rear bumper designed for use on B-MAX2 / MR chassis. It serves as the mounting point for the rear wing while providing an integrated bumper interface to manage minor impacts and preserve body alignment during running.

Compatibility is limited to the B-MAX2 / MR series as stated, so verify your chassis code before purchase. The part’s mid-position designation affects wing height and lever arm relative to the chassis centreline, which in turn influences rear downforce and balance during cornering.

Installation is straightforward for users familiar with typical touring car assemblies: remove the existing rear wing mount and bumper assembly, align the YOKB2-001WB with the chassis mounting points, and secure it using the original hardware. No additional tools beyond standard hex drivers are required, but check thread engagement and clearances before first run.

Tuning notes: moving the wing mounting point to a mid position typically shifts aerodynamic load distribution, offering a balance between high-downforce rear setups and lower-drag configurations. Use this part when adjusting rear grip and rotational behaviour, and combine with incremental wing angle changes to dial handling.